Bamboo-shaped Ag-doped TiO2 nanowires with heterojunctions

Bamboo-shaped Ag-doped TiO2 nanowires with heterojunctions were synthesized by a simple solvothermal method. The diameter of the nanowires was about 50-100 nm, and they had a length of up to a few millimeters. The detailed structure of the heterojunction in the nanowire was also characterized.     

Controlled growth of large-area, uniform, vertically aligned arrays of alpha-Fe2O3 nanobelts and nanowires

Vertically aligned iron oxide nanobelt and nanowire arrays have been synthesized on a large-area surface by direct thermal oxidation of iron substrates under the flow of O(2). The effects of reactive gas pressure, composition, and temperature have been systematically studied. It was found that nanobelts (width, tens of nanometers; thickness, a few nanometers) are produced in the low-temperature region (approximately 700 degrees C) whereas cylindrical nanowires tens of nanometers thick are formed at relatively higher temperatures (approximately 800 degrees C). Both nanobelts and nanowires are mostly bicrystallites with a length of tens of micrometers which grow uniquely along the [110] direction. The growth habits of the nanobelts and nanowires in the two temperature regions indicate the role of growth rate anisotropy and surface energy in dictating the ultimate nanomorphologies.     

1β—Methyl Carbapenem中间体的合成

综述了１β－Ｍｅｔｈｙｌ Ｃａｒｂａｐｅｎｅｍ中间体的合成方法，重点强调了如何构筑１位β构型的甲基。参考文献３７篇。     

4-(N-甲酰基-N′-邻氯苯基硫脲)-N-邻氯苯基苯氧乙酰胺的核磁共振研究

在超声波辐射下,以PEG-400为固-液相转移催化剂,用邻氯苯胺与双酰基异硫氰酸酯反应,合成出了一种新的化合物——4-(N-甲酰基-N′-邻氯苯基硫脲)-N-邻氯苯基苯氧乙酰胺。实验中观察到了取代和加成反应的竞争。利用元素分析,1H、13C、APT及二维核磁共振技术确定了所合成的新化合物的结构。给出了该化合物的化学位移数据。所得的结果对这类化合物的结构解析很有价值。     

助剂对Cu/Cr催化剂上甲醇部分氧化制氢的活性影响

曾研究了Cu/Cr二元催化剂上甲醇部分氧化制氢的反应，发现当Cu/Cr比为6：4时，催化剂的Cu^0比表面积最大，呈现出较好的活性。在Cu/Cr（6：4）催化剂中添加Fe,Zn,Al等8种助剂，考察其对甲醇部分氧化制氢催化性能的影响，并着重研究了Zn助剂的作用。实验结果表明，Zn的引入，有利于催化剂活性的提高。当Zn含量为10％时，催化剂活性最好。XRD表征结果表明，Cu/Cr催化剂的失活与其表面上的Cu物种烧结有关，Zn的引入可明显增强Cu/Cr（6：4）催化剂的热稳定性，提高其寿命。     

Research on Crystal Structure of the Complex of 10－Hydroxy－10－（3－indolyl）－9－phenanthrenone with Tetrahydrofuran

ＲｅｓｅａｒｃｈｏｎＣｒｙｓｔａｌＳｔｒｕｃｔｕｒｅｏｆｔｈｅＣｏｍｐｌｅｘｏｆ１０－Ｈｙｄｒｏｘｙ－１０－（３－ｉｎｄｏｌｙｌ）－９－ｐｈｅｎａｎｔｈｒｅｎｏｎｅｗｉｔｈＴｅｔｒａｈｙｄｒｏｆｕｒａｎＭｅｎｇＪｉ－Ｂｅｎ；ＷｅｎＺｈｏｎｇ；Ｗａｎｇ...     

聚（3—丁基噻吩）电导的热稳定性

研究了导电聚合物聚（３－丁基噻吩）（ＰＢＴ）在大气环境下的导电热稳定性。在室温至２２０℃范围内，测试电导率随时间及温度的变化。ＴＧＡ分析以及化学分析的结果表明：掺杂态的ＰＢＴ大约在１４０℃附近有一转化温度，低于或高于这一转化温度，电导率下降的决定因素各不相同。高于转化温度时，电导率下降的主要原因是反离子和高分子主链的解离，进而发生化学反应，影响了高分子主链的结构。ＸＰＳ测试结果表明：经热处理后的Ｐ     

A New HPLC Method to Determine Carbonyl Compounds in Air

In this paper,a new HPLC method was established to determine the earbonyl compounds in air.As the absorbent,2,4-dinitrophenylhydrazint(2,4-DNPH)reaeted with earbonyls specifieally,which form the corresponding 2,4-dinitrophenylhydrazones,then analyzed by HPLC.The chromatographic conditions,the recovery rate,stability of samples,reagent blank,sampling efficiency were all studied systematically.The results showed that this established method had high sensitivity and good selectivity compared with other analytical methods,and it can detemine ten earbonyl compounds in air in 26 min simultancously.     

Synthesis and Crystal Structure of （Et4N）2[Pd2（mp）2（mpH）2]

ＳｙｎｔｈｅｓｉｓａｎｄＣｒｙｓｔａｌＳｔｒｕｃｔｕｒｅｏｆ（Ｅｔ_４Ｎ）_２［Ｐｄ_２（ｍｐ）_２（ｍｐＨ）_２］ＳｈｉＪｉ－Ｃｈｅｎｇ；ＨｕａｎｇＸｉａｏ－Ｙｉｎｇ；ＷｅｎＴｉｎｇ－Ｂｉｎ；ＤｅｎｇＹｕ－Ｈｅｎｇ；ＣｈｅｎｇＣｈａｎｇ－Ｎｅｎｇ；Ｌｉ?..     

制备参数对β-Mo2N0.78催化剂加氢脱硫活性影响的研究

以N2与H2的混合气为反应气，和三氧化钼进行多段程序升温反应，制得一种β晶型的氮化钼。以噻吩为模型化合物的常压加氢脱硫反应表明，β-Mo2N0.78具有较强的加氢脱硫活性和强的抗硫化性能。同时考察了预还原、反应温度以及氮化末温、升温速率、反应气中N2-H2比及氮化时间等制备参数对β-Mo2N0.78加氢脱硫活性的影响。研究发现，β-Mo2N0.78的加氢脱硫活性在320 ℃～400 ℃随反应温度的升高增强，而还原预处理会降低催化剂的活性。氮化末温、氮化时间、反应气组成和升温速率等制备参数对催化剂的活性有明显的影响：随着氮化末温的升高，所制备的催化剂催化加氢脱硫活性降低；在氮化末温恒温较长时间，可以引起制备催化剂的加氢脱硫活性下降；存在最佳的反应气组成和各段升温速率。小晶粒的β-Mo2N0.78具有强的加氢脱硫活性。